Slurry Pump Wetted Parts Throat Bush F6083WR-T05

Tobee® 8/6F-AH Horizontal Slurry Pump wearing parts with high chrome alloy materials - Throat Bush F6083WR-T05, It can replace original pump parts in the Mining. The Parts: impeller and throat bush combination with improved hydraulic profiles, reduced turbulence, extended wear performance of between 30% and 50% and lowered power consumption.

Replacement of parts is a maintenance requirement when operating slurry pumps, and can’t be ignored. When your machinery is pumping solids, destructive wear will occur over a period of time. This part of wear and tear is inevitable, therefore you need a helper to rely on to replace the parts effectively, efficiently, and affordably.

Tobee® as a manufacturer with the facilities to support the largest mining, mineral processing, aggregate, and general industry customers

Slurry Pump Main parts:

• Bearing assembly - A large diameter shaft with short overhang minimizes deflection and contributes to long bearing life. Only four through bolts are required to hold the cartridge type housing in the frame.
• Liners - Easily replaceable liners are bolted, not glued, to the casing for positive attachment and ease of maintenance. Hard metal liners are completely interchangeable with pressure molded elastomer. Elastomer seal rings back all liner joints.
• Casing - Casing halves of cast or ductile iron with external reinforcing ribs provide high operating pressure capabilities and an extra measure of safety.
• Impeller - front and rear shrouds have pump out vanes that reduce recalculation and seal contamination. Hard metal and molded elastomer impellers are complete interchangeable. Cast in impeller threads require no inserts or nuts. High efficiency and high head designs are also available.
• Throat bush - Wear is reduced and maintenance simplified by the use of tapered mating faces to allow positive accurate alignment during assembly and simple removal.

For the High chrome alloy parts, the standard is High chrome Alloy(27% Cr), it can be used from PH 5 to 12, and its hardness can be to HRC65, which is a very good choice for slurry control and transport. But in some conditions, the PH may lower than 5, then we try to use A49, it can lower to PH4, mostly used in FGD processing, Tobee offers the full chrome alloy parts including A03, A04, A05, A06, A07, A12, A14, A25, A33, A49, A51, A61 etc.

Slurry Pump Throat Bush Code: