Andritz ACP150-400.5 DD centrifugal pump parts front lining can be used in paper and pulp industry, sugar production, water supply, sewage pumping and production of bioethanol.
Tobee® manufacture a range of replacement parts including impellers(2 vanes, 3 vanes, 6 vanes, 8 vanes), casings, casing cover, front lining, rear lining, stuffing box body, shaft etc which for Andritz S series pumps, ACP series pumps, FP series pumps etc
Tobee® Pump is always making continuous optimization of materials like Cast steel, EPDM, Hypalon, Hastelloy, CD4MCu, Viton, Fluoroplastic, Ceramic, Bronze, Titanium, Aluminum and other anti-abrasive & corrosive materials for various applications.
Such as impeller: EN-GJL 250, 1.4460 and 1.4517, casing/casing cover: EN-GJL 250 and 1.4460, volute casing: EN-GJL 250, EN-GJS-400-15 and 1.4460, bearing housing EN-GJL 250 and 1.4468, front and rear lining: 1.4460 and 1.4517, stuffing box body EN-GJL 250, 1.4460 and 1.4408, shaft: 1.4021 & 1.4462 and 1.4404 & 1.4439, etc.
ANDRITZ S & ACP Series Centrifugal Paper Pulp Pumps are available with closed, semi-open or open impellers with 3 vanes or 6vanes in a highly wear-resistant design. These pumps are suitable for conveying many different media. Depending on the impeller design, they can convey slightly contaminated and contaminated media with some solids and content up to consistencies up to 8%. S series and ACP series paper pulp pumps are wide used in the pulp and paper, mining, offshore, power, food, and chemical industry. Additionally, water supply, waste water treatment, desalination plants, and irrigation as well as drainage etc.
ACP Centrifugal Pump Design:
Impeller(230)
• Accelerating the medium by charging it with energy.
• Semi-open impeller with vanes on the back.
Spiral casing (102)
• Guiding the medium with a favorable flow pattern, converting speed energy into pressure energy.
• Pressure-sealed pump casing with delivery and suction channels.
• Suction and delivery flange.
• Holds the bearing housing with bearing assembly, shaft and impeller.
Pump shaft (211)
• Holding the impeller, shaft seal, bearing assembly and coupling.
• Transmitting the drive energy to the impeller and thus, to the medium.
• Sturdily dimensioned drive shaft.
Bearings
• Interface between stationary and rotating parts. Absorption of axial and radial forces.
• Impeller side: Two angular contact ball bearings (321.1) with steel cage.
• Drive side: One deep groove ball bearings (321.2) with steel cage.
Shaft seal
Depending on operating requirements, there is a choice of eight different shaft seals:
• Cartridge mechanical seal - single
• Cartridge mechanical seal - double
• Standard cartridge mechanical seal - single
• Standard cartridge mechanical seal – double
• Single standard mechanical seal
• Tandem mechanical seal
• Stuffing box packing
• Dynamic shaft seal
Added to subscribe successful !
