Tobee manufacture replacement Andritz S series Pumps and Parts, Andritz ACP series Pumps and Parts, Andritz FP series Pumps and Parts, Andritz VP series Pumps and Parts, Andritz CP series Pumps and Parts etc.
Tobee® manufacture a range of replacement parts including impellers(2 vanes, 3 vanes, 6 vanes, 8 vanes), casings, casing cover, front lining, rear lining, stuffing box body, shaft etc which for Andritz S series pumps, ACP series pumps, FP series pumps, VP series pumps, CP series pumps etc.
ANDRITZ ACP and S series Pump Specifications:
Design:single-stage, single-flow, open and semi-open impeller
Consistency:up to 8%
Head:10-180 m
Flow rate:up to 8,000 m3/h
Pressure:up to 40 bar
Temperature:up to 200℃
Efficiency:up to 90%
Andritz ACP Centrifugal Pump Design:
Impeller(230)
• Accelerating the medium by charging it with energy.
• Semi-open impeller with vanes on the back.
Spiral casing (102)
• Guiding the medium with a favorable flow pattern, converting speed energy into pressure energy.
• Pressure-sealed pump casing with delivery and suction channels.
• Suction and delivery flange.
• Holds the bearing housing with bearing assembly, shaft and impeller.
Pump shaft (211)
• Holding the impeller, shaft seal, bearing assembly and coupling.
• Transmitting the drive energy to the impeller and thus, to the medium.
• Sturdily dimensioned drive shaft.
Bearings
• Interface between stationary and rotating parts. Absorption of axial and radial forces.
• Impeller side: Two angular contact ball bearings (321.1) with steel cage.
• Drive side: One deep groove ball bearings (321.2) with steel cage.
Andritz ACP Centrifugal Pump Shaft seal:
Depending on operating requirements, there is a choice of eight different shaft seals:
• Cartridge mechanical seal - single
• Cartridge mechanical seal - double
• Standard cartridge mechanical seal - single
• Standard cartridge mechanical seal – double
• Single standard mechanical seal
• Tandem mechanical seal
• Stuffing box packing
• Dynamic shaft seal
EN-GJL 250, 1.4460 and 1.4517, casing/casing cover: EN-GJL 250 and 1.4460, volute casing: EN-GJL 250, EN-GJS-400-15 and 1.4460, bearing housing EN-GJL 250 and 1.4468, front and rear lining: 1.4460 and 1.4517, stuffing box body EN-GJL 250, 1.4460 and 1.4408, shaft: 1.4021 & 1.4462 and 1.4404 & 1.4439, etc.
Added to subscribe successful !
